How To Fix Mic On Turtle Beach Headset

Turtle Beach PX22 Microphone Replacement

Comments: 3
Favorites: 2
Completions: 2

Turtle Beach PX22 Microphone Replacement

Time Required

25 - 30 minutes

Microphone 4 steps

Introduction

If your microphone does not work after troubleshooting with our guides it may need to be replaced. This guide will show the user how to remove a broken microphone and replace it with a new microphone.

Use your fingers to peel off ear cushion by pinching and pulling off the leather. Use the Philips #00 head screwdriver to remove three screws around the speaker (9/32 in length, 1/8 inch head) The housing will comes loose. Take note of position of the wires.

Use your fingers to peel off ear cushion by pinching and pulling off the leather.
Use the Philips #00 head screwdriver to remove three screws around the speaker (9/32 in length, 1/8 inch head)
The housing will comes loose. Take note of position of the wires.

Remove the 9/32 inch screw with a Philips 2 screwdriver to gain access to microphone.

Remove the 9/32 inch screw with a Philips 2 screwdriver to gain access to microphone.
You may need to pull the wire with the knot out of the way of the screw.

Apply heat to the circled wires on the circuit board with a heat gun.

Apply heat to the circled wires on the circuit board with a heat gun.
Insert the new microphone and solder the wires into the correct positions.
Pull the excess microphone wire back into the speaker housing.
Use the Philips #2 screwdriver to replace the screw and fix the microphone.
Hold the microphone neck so that it does no rotate when screwing.

Position the speaker on the headset so that the screw holes line up. It should click into place. Screw in the 3 screws with the 00 Philips head screwdriver. Place the new cushion against speaker and wrap the leather around the plastic. Do this by working around the cushion to get all of the leather around the plastic.

Position the speaker on the headset so that the screw holes line up. It should click into place.
Screw in the 3 screws with the 00 Philips head screwdriver.
Place the new cushion against speaker and wrap the leather around the plastic. Do this by working around the cushion to get all of the leather around the plastic.
Use the plastic opening tool to tuck excess leather inside the headset.

Almost done!

To reassemble your device, follow these instructions in reverse order.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Team

3 Comments

could someone help me say what each and every on of those wire points on this logic board goes to? like 1,2,3,4,5 and 6, what do they go to???

alexalv55 - 05/18/2018 Reply

i need the cable for my px 24 it broke in my phone how do i get a new cable to fix my px 24 headset

rjbubba1960 - 07/07/2020 Reply